Advertisement
H
C
and
ontrol
11. LEG REST DOWN BUTTON
Press and hold to lower the leg rest.
12. MEMORY BUTTONS (HAND CONTROL C ONLY)
Press and hold Memory Button 1 and Memory Button 2. The LEDs on the memory buttons will flash
to indicate that the hand control is in "set" mode. Press and hold the desired memory button to set the
memory position. The LEDs will stop flashing. To go to a preset memory position, press and hold the
desired memory button.
13. HEAT CONTROL BUTTON (HAND CONTROL C ONLY)
Press the heat button to activate the heat function. Press the HEAT button again to cycle intensity
through LOW, HIGH and OFF.
CUP HOLDER
Figure 2. Cup Holder
If your chair is equipped with cup holders, ensure the cup holders are empty prior to elevating your chair
above a seated positon to a standing position. See figure 2.
WARNING! Any contents in the cup holder may shift or spill when the chair is raised.
Remove all contents prior to elevating your chair. Failure to remove all contents from
the cup holders prior to elevating your chair above a seated position may result in
personal injury or property damage.
WARNING! NEVER place lit tobacco products in the cup holders or attempt to use the
cup holders as an ashtray.
r
G
eferenCe
uide
CUP HOLDER
CUP HOLDER
Follow these steps to properly stand up from
your chair:
1. Activate and hold the UP button (switch) to
raise your chair.
2. Release the button (switch) when the chair
reaches a height where you can stand up
comfortably.
WARNING! Do not attempt to stand
up until you can stand safely, are
steady on your feet, and can bear
weight. Pride recommends the
use of assistance aids and/or an
attendant for enhanced stability.
WARNING! Avoid putting all of
your weight on the chair armrests
when attempting to stand and do
not use the armrests for weight
bearing purposes.
3
Advertisement
