Changing Door Hinges; Door Panel - Dometic RM 2552 Installation And Operating Instructions Manual

ODOR FROM FUMES
CAUSES AND REMEDIES
A. The flame touches side of the boiler due to dislocation
of the burner. Relocate. Burner dislocation may also
cause smoke and discoloring of walls and ceiling.
B. Burner damaged. Replace.
All the above instructions are to be followed closely. The
refrigerator is quality-guaranteed. However, we are not
responsible for any failures caused by improper adjust-
ments and unfavorable installation conditions. Contact
service point or distributor service dept. for assistance.
Replacement Parts Suppliers: See page 1.
CHANGING DOOR HINGES FROM
ONE SIDE TO THE OTHER
The refrigerator is equipped with a convertible door.To
change the door swing, consult the parts manual for the
Conversion Kit Number. For further information, please
contact the Dometic Corporation listed on the front page.
INSTRUCTIONS FOR MOUNTING
THE DOOR PANEL
The refrigerator is normally delivered without door pan-
els. Before starting the mounting work, check that the
panel dimensions are in compliance with those given in
the table and the instructions are read thoroughly.
When mounting the panel, proceed as follows:
See figure page 14.
A. Open the door 90 degrees.
On new refrigerators, the decoration strips are taped
inside the door; if installed on the door, remove the
door decoration strip (2) by removing its three screws
(1).
B. Insert the vertical edges into the grooves of the door
frame (3).
C. Push the panel downward so that the lower horizontal
edge of the panel (4) is fitted into the bottom groove
(5).
D. Put the decoration strip across the door so that the
gap is covered.
Secure the decoration strip with the three screws
removed in Step A (1).
PANEL DIMENSIONS
MAX. THICKNESS 5/32" (4 mm)
REFR.MODELS HEIGHT
TYPE MAX.
RM 2552
RM 2553
mm 983
inch 38-11/16
WIDTH
MIN. MAX. MIN.
981 527 524
38-5/8 20-3/4 20-5/8
13