Hanging The Fan-Close-To-Ceiling Mounting - Aire Magnitude 34348 Instruction Manual Warranty Certificate

HANGING THE FAN-CLOSE-TO-CEILING MOUNTING

WARNING: All of the parts, hardware and components such as the hanger bracket and hanger ball have been provided
for your safety and the proper installation of your new ceiling fan. The use of other parts, hardware or components not
supplied by Aire with the fan will void the Aire Warranty.
REMEMBER to turn off the power. Follow the steps below to hang your fan properly:
Step 1. Remove the canopy ring from the canopy by turning the canopy ring counterclockwise. Remove the mounting
bracket from the canopy by loosening the four screws on the top of the canopy. Remove the two non-slotted screws and
loosen the slotted screws. (Figure 14)
Step 2. Remove the decorative canopy bottom cover from the canopy by turning the canopy bottom cover
counterclockwise. (Figure 15)
Step 3. Pass the 120-volt supply wires through the center hole in the mounting bracket. Attach the mounting bracket on
the outlet box by sliding the mounting bracket over the screws provided with the outlet box. When using
"close-to-ceiling" mounting, it is important that the mounting bracket be level. If necessary, use leveling washers (not
included) between the mounting bracket and the outlet box. Note that the flat side of the mounting bracket is toward the
outlet box. (Figure 16)
Step 4. Route the wires exiting the top of the fan motor through the canopy. Then proceed to place the ceiling canopy
over the collar at the top of the motor. Align the mounting holes with the holes in the motor and fasten using the screws
and lock washers provided. (Figure 17)
Step 5. Hang the fan on the hook of the hanger bracket. Be certain that the canopy is fully locked into hook as shown in
Figure 18.
LOOSEN
BUT DO NOT
REMOVE
CANOPY RING
FIG. 14
REMOVE
CANOPY
FIG. 15
SCREW AND
LOCKWASHER
CANOPY
CANOPY
RING
COLLAR
FIG. 17
CANOPY
BOTTOM
COVER
HOOK
FIG. 18
9
OUTLET BOX
HANGER BRACKET
FIG. 16