Table of Contents
Advertisement
Available languages
Available languages
Maintenance
*Only when the air cleaner is switched off and disconnected from the power supply can it be cleaned, or electric
shocks and injuries may occur.
Cleaning the air outlet port and shell:
•
Do not use gasoline, benzene, diluents, polishing powder, or liquid insecticide to clean them. Do
not clean them with hot water at above 50° C to avoid fading or damage.
•
Wipe them with a soft dry cloth.
•
Water or neutral dry cleanser is recommended if the dust cannot be removed. The Wind Deflector
can be dismantled to clean (as below).
Cleaning the Filter
•
Cleaning
Clean the air cleaner with a vacuum cleaner or water to remove dust.
If there is too much dust, use the fan or directly spray the special cookware detergent on the air inlet grid, and
then clean it with water after 10 minutes.
(A) remove dust with a vacuum cleaner.
(B) for excessive dust, use a soft-hair brush and a mild detergent to clean.
(C) Allow filter to dry fully before reinstalling.
•
Do not clean with hot water of over 50°C to avoid fading or distortion.
•
Do not dry on the fire, or the cleaner might cause fire.
Attention
Attention
12
5
Advertisement
Chapters
Table of Contents
