Adding And Removing Gbics - Extreme Networks BlackDiamond 6800 Hardware Installation Manual

A
DDING AND
GBICs can be added and removed from the BlackDiamond 6800 switch without
powering off the system. The two types of GBIC connectors are shown in
Module A
Figure 3-4: GBIC connectors
GBICs are a Class 1 laser device. Use only Extreme-approved devices.
To remove the GBIC connector labeled "Module A," lift up on the front handle and pull
the GBIC out of the slot.
To remove the GBIC connector labeled "Module B," gently squeeze the sides to release
it, and pull the GBIC out of the slot.
Ensure that the SC fiber-optic connector is removed from the GBIC prior to
removing the GBIC from the I/O module.
Caution: Invisible laser radiation can occur when open. Avoid direct eye exposure
to beam.
To insert a GBIC connector, follow these steps:
1 Holding the GBIC by its sides, insert the GBIC into the slot on the I/O module.
2 Slide the GBIC as far back into the slot as possible, until you hear it click.
3 If the GBIC has a handle, push down on the handle to secure the GBIC in the slot.
B D S H
LACK IAMOND WITCH ARDWARE
R
EMOVING
I G
NSTALLATION UIDE
GBIC
S
Module B
EW_GBIC
A R GBIC
DDING AND EMOVING S
Figure 3-4.
3-7