Table of Contents
Advertisement
OWI User Manual: Model AMP-R2SIC5 / AMP-R2SIC6 Speaker Amplifier
Model AMP-R2SIC5 / AMP-R2SIC6 Speaker Amplifier
cutting a small hole in the center of your penciled mounting hole with a drywall or keyhole saw,
cutting at a 45 degree angle towards the inside of the hole. Cutting a small hole at this angle
will make drywall repair much easier. Once you have determined there are no obstructions in
your desired mounting location, start cutting the finished hole at a 90 degree angle to the
ceiling surface.
Route the speaker wires from your amplifier to your opening. Avoid routing the speaker wire
near electrical wires. If you have to run them parallel, make certain to space the speaker wires
at least 2 feet from the AC line. Do not nail or staple the speaker wire.
Prepare Your OWI Speakers for Mounting
Insert a paper clip into one of the grille openings, then pull upwards to remove the grille.
Turn the mounting tab 90° and push toward the grill. The grill will safely pop off.
Be sure to position the four Mounting Tabs on your OWI speaker inward then insert the
four (4) screws (supplied) from the front of the speaker into the screw opening.
OWI INC.
15
www.owi-inc.com
Advertisement
Table of Contents
