Maintenance Instructions:
Aprilaire Model 110 Humidifier
1. Note manual humidifier control setting and turn dial to the "off" position.
2. Disconnect electrical power, turn water supply off.
3. Disconnect
a. 120 volt electrical service.
b. Copper Water Supply Line (1) and feed tube (2).
c. Drain line. d) 24 volt leads.
4. Turn two swing locks (3), one at either side of the lower housing of humidifier
flange
5. Lift humidifier straight up until bottom of t humidifier clears lip of lower
housing. Pull humidifier out at bottom, lower and remove.
Slide off three closure clips (4 & 5) that hold 2 halves of humidifier together.
6. Remove upper half of humidifier. Remove water distribution pan cover (6)
and remove any mineral deposits from the "V" notches. DO NOT scrape off
granular coating from the bottom. This textured surface helps ensure even
water flow for maximum performance. If the granular coating has been
removed. Place several drops of liquid dishwashing soap on the distribution
tray. This will only need to be done once if there is no granular coating.
7. Remove water panel evaporator and scale control insert
8. Remove water panel evaporator from insert and clean insert by flexing or
using putty knife. If scale control insert is not used, contact your dealer
about obtaining one.
9. Install a new water panel evaporator with colored spot UP, in scale control
insert. IMPORTANT: when installing scale control insert and water panel
evaporator into the humidifier, the insert spout must discharge directly into
the drain.
10. Remove drain line (7) from the bottom of the humidifier. If applicable, flex it
to loosen any mineral deposits or blockages. Then flush it with water under
pressure. If it does not properly clear, replace it. Slip the drain line back onto
the drain fitting. Make sure the drain line has a constant downward slope and
is not flattened or blocked.