Advertisement
STEP 3
(See Diagram 3)
A.) Attach the Leg Developer (#7) to the Front Post (#5). Secure it with one M10 x 2 ¾" Allen Bolt
(#36), two ∅ ¾" Washers (#45), and one M10 Aircraft Nut (#47).
B.) Attach the Arm Curl Handle (#14) to the open bracket on Leg Developer. Secure it with a L-
shaped Lock Pin (#26).
C.) Attach the Butterfly Handle (#16) to right Butterfly (#15). Secure it with one M10 x 5/8" Allen
Bolt (#42) and one Ø ¾" Large Washer (#46). Repeat same step to install the other Butterfly
Handle to the left Butterfly.
D.) Do not over tighten Nut and Bolts. Make sure the Leg Developer and Butterfly can
swivel freely.
©Impex
8
DIAGRAM 3
www.marcypro.com
Advertisement
