Advertisement
Safety Information
• The supplied battery charging cable
has been tested to work with the
Apple iPhone power adaptors. While
Caution
it can be used in other USB ports e.g.
• Risk of electric shock
computer, USB power adaptors, TVs,
• Do not open/disassemble the
cars etc., correct operation cannot be
motorized roller system
guaranteed.
• Do not disassemble the device.
• When the device is no longer in use,
Incorrect reassembly can cause
please recycle it properly.
electrical shock if the device is
used again.
Usage Environment
• Do not immerse the device in water or
• To protect the high-precision
other fluids.
technology contained in this device,
• Do not operate the device in a high
never leave the camera in the following
humidity environment or very dusty
environments for extended periods of
environments.
time: high temperature (+42°C/108°F),
• Do not attempt to tamper with, adjust
high humidity, places with extreme
or remove the battery and/or the
changes in temperature (hot and
electronics located below the rollers
cold), direct sunlight, sandy or dusty
behind the device's film door.
environments such as beaches, damp
• Do not attempt to remove the door
places, or places with strong vibrations.
itself as it is connected electronically
• Do not drop the device or subject it
to the body of the device. Doing so is
to severe shocks or vibrations.
unsafe, will likely damage your device,
• Do not push, pull or press on the lens.
and will void your warranty.
• Do not insert metal objects into the
device.
• Do not insert any objects into the
Compliance
rollers or gears.
• Keep small children and infants away
Important directions for using Lithium–
from device to avoid them being injured
Ion Batteries:
by the device's moving parts.
1. Do not throw into fire.
• Do not use or store the device near any
2. Do not short circuit.
heat source or any type of equipment
3. Do not disassemble.
that generates heat, including stereo
4. Do not continue to use when damaged.
amplifiers.
5. Dispose correctly after use.
• Do not use the device near flammable
6. Keep away from water.
or explosive gases.
7. Do not charge when the temperature is
• Do not charge the device if you notice
below freezing.
any unusual odors, noise or smoke.
• Do not attempt to disassemble the
EU Declaration of Conformity
film's battery or modify it in any way (if
Hereby, Polaroid Film B.V. declares that
using 600-type film). If battery fluid gets
the Polaroid Now+ analog instant camera
in your eyes, immediately rinse your
is in compliance with the essential
eyes with fresh, cold running water and
requirements of the Electromagnetic
seek medical attention immediately.
Compatibility Directive (2014/30/EU),
• Do not cover the flash.
Low Voltage Directive (2014/35/EU) and
RoHs Directive (2011/65/EU) and other
Battery & Charger
relevant provisions, when used for its
• This device uses a custom lithium-ion
intended purpose.
battery that is non-removable and
mounted inside the camera body. No
FCC Compliance Statement
other type of battery can be used.
Contains FCC ID: A8TBM70ABCDEFGH
Battery replacement can only be done
This device complies with Part 15 of
by authorized service centers. The
the FCC Rules. Operation is subject to the
battery will provide many years of
following two conditions: (1) this device
service if properly used.
may not cause harmful interference,
• Power consumption varies depending
and (2) this device must accept any
on the environment the device is used
interference received, including
in and how the device has been stored.
interference that may cause undesired
Used immediately after full charge, the
operation.
battery will power the processing of up
Caution the user is cautioned that
Caution
to 15 film packs.
changes or modifications not expressly
• Once the battery energy level falls
approved by
below a certain level, the device will
the party responsible for compliance
no longer process film. The LED will
could void the user's authority to operate
blink and signal when it needs to be
the equipment. This equipment must not
recharged. This is to avoid a photo
be co-located or operated in conjunction
getting stuck as it is being processed
with any other antenna or transmitter.
through the roller system.
Note
Note his equipment has been tested
• The rechargeable battery is not fully
and found to comply with the limits for
charged at the time of purchase. Charge
a Class B digital device, pursuant to
the battery fully with the USB charging
part 15 of the FCC rules. These limits
cable (provided). This usually takes 1-2
are designed to provide reasonable
hours (can vary depending on usage).
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to
radio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
- Reorient or relocate the receiving
antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced
radio/TV technician for help.
This equipment complies with FCC
radiation exposure limits set forth for an
uncontrolled environment. End user must
follow the specific operating instructions
for satisfying RF exposure compliance.
Industry Canada (IC)
Contains ID: 12246A-BM70BLES1F2
CAN ICES-003(B)/NMB-003(B)
This device complies with part 15
of the FCC Rule and Industry Canada
license–exempt RSS standard(s).
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless
Device is below the Industry Canada
(IC) radio frequency exposure limits. The
Wireless Device should be used in such
a manner such that the potential for
human contact during normal operation
is minimized.
This device has also been evaluated
and shown compliant with the IC RF
Exposure limits under portable exposure
conditions. (antennas are less than 20 cm
of a person's body).
The symbol means that according to
local laws and regulations your
product should be disposed of
separately from household waste. When
this product reaches its end of life, take it
to a collection point designated by local
authorities. Some collection points
accept products for free. The separate
collection and recycling of your product
at the time of disposal will help conserve
natural resources and ensure that it is
recycled in a manner that protects human
health and the environment
Polaroid Film B.V.
P.O. Box 242
7500 AE Enschede
The Netherlands
End of life disposal warning: when the product has come to the end of life, dispose of it in
accordance with local regulations. This product is subject to the Directive 2012/19/EU on
waste electrical and electronic equipment (WEEE) and should not be disposed as unsorted
municipal waste.
Made in China for and distributed by Polaroid Film B.V. (P.O. Box 242, 7500 AE), Enschede, The
Netherlands. Polaroid and Polaroid Now+ as well as the logos, the Polaroid Lockup, the Polaroid
Color Spectrum, and the Polaroid Classic Border Logo are trademarks of PLR IP Holdings, LLC,
which is part of the Polaroid group of companies.
© 2021 Polaroid. All Rights Reserved.
Advertisement
