Lennox LM018CI-100P432-1 Owner's Manual page 13

Introduction for buttons on remote controller
indicates the guide louver swings as:
5
button
Press this button to decrease set temperature. Holding it down above 2 seconds
rapidly decreases set temperature. In AUTO mode, set temperature is not adjustable.
6
FAN button
This button is used for setting Fan Speed in the sequence that goes from AUTO,
, to , then back to Auto.
7
TIMER OFF
Press this button to initiate the auto-off timer. To cancel the auto-timer program,
simply press the button again.TIMER OFF setting is the same as TIMER ON.
8
CLOCK button
Press CLOCK button,
the present time. Holding down either button above 2 seconds increases or decreases
the time by 1 minute every 0.5 second and then by 10 minutes every 0.5 second. During
blinking after setting, press CLOCK button again to confirm the setting, and then
will be constantly displayed.
9
TIMER ON button
Press this button to initiate the auto-ON timer. To cancel the auto-timer program, simply
press this button again.
After press of this button,
setting. Within 5 seconds, press ▲ or
either button changes the time setting by 1 minute. Holding down either button rapidly
changes the time setting by 1 minute and then 10 minutes. Within 5 Seconds after
setting, press TIMER ON button to confirm.
10
SLEEP button
Press this button to go into the SLEEP operation mode. Press it again to cancel this
function. This function is available in COOL, HEAT (Only for models with heating
function) to maintain the most comfortable temperature for you.
11
TEMP button
Press this button, you can see indoor set temperature, indoor ambient temperature
Auto
Low speed
button
blinking. Within 5 seconds, pressing ▲ or
disappears and "ON "blinks. 00:00 is displayed for ON time
Medium speed
button to adjust the time value. Every press of
10
High speed
button adjusts