Table of Contents
Advertisement
ENGLISH
FITTING AND REMOVING THE ADJUSTABLE PRECISION COMB (FIG. D)
•
Clip the adjustable comb over the blade as shown ensuring that the three tabs on the
comb fit into the notches on the back of the blade (shown by the s marks).
•
The 0.5 - 5 mm comb can be adjusted in 0.5mm increments simply by turning the wheel
until the desired setting is shown on the scale. Turn the wheel clockwise for longer
length and anticlockwise for shorter length.
•
To remove, lift the back of the comb upwards and lift it off the blade.
INSTRUCTIONS FOR USE
Switch the product on by rotating the on-off switch to the I mark.
Always comb your beard or moustache with a fine comb before you start trimming.
TO TRIM THE BEARD
1. Fit the adjustable comb. If you are trimming for the first time start with the maximum
trimming length setting.
2. Turn the unit on.
3. Place the flat top of the comb against the skin.
4. Slowly slide through the hair. Repeat from different directions as necessary.
5. If hair builds up in the trimmer comb during the trimming process, switch the unit off,
pull off the comb and brush the hair off.
TO GET A SHAVEN LOOK
To trim any length of beard or stubble hair for a clean, shaven look then follow the above
steps without a comb attached to the blade head.
Place the flat top of the blade against the skin and slowly slide through the hair against the
direction of growth.
Shave in an upwards direction when shaving under the chin (Fig. A).
TRIMMING AND EDGING
1. Hold the device with the back side of the blade facing you with no combs attached.
2. Start with the blades resting lightly against your skin, use motions towards edge of
beard line to trim to desired locations in facial area.
3. Shape as desired.
TRIMMING WITH SHAVING GEL
Follow the same instructions as dry shaving if using shaving gel.
Caution: After use with shaving gel, please rinse the blade under warm water to clean away
any excess gel and debris.
DETAILED NOSE, EYEBROW AND EAR HAIR TRIMMING
Attachments
Micro trimmer
6
Advertisement
Table of Contents
