Service And Repair; Disposal; Troubleshooting - RIDGID SeeSnake NanoReel Operator's Manual

Service and Repair

Improper service or repair can make the nanoReel
unsafe to operate.
Service and repair of the SeeSnake nanoReel must be
performed at a RIDGID Independent Authorized Service
Center.
For information on your nearest RIDGID Independent
Service Center or any service or repair questions:
Problem
Camera image not seen
"SOS" code blinking on LCD*
* The light on the LCD will only blink the "SOS" code on some SeeSnake CCUs.
1.800.544.2843
WARNING
Probable Fault Location
No power to SeeSnake CCU or
CA-300 camera monitor connector
Connections faulty
Monitor set to wrong source
Batteries low
No video signal
www.calcert.com
15
10 20
5 25
0 30

Disposal

Parts of the nanoReel contain valuable materials that
can be recycled. Companies that specialize in recycling
may be found locally. Dispose of the components in
compliance with all applicable regulations. Contact your
local waste management authority for more information.
For EC Countries: Do not dispose of
electrical equipment with household waste!
According
2002/96/EC
Electronic Equipment and its implementation
into national legislation, electrical equipment
that is no longer usable must be collected separately
and disposed of in an environmentally correct manner.
Table 3

Troubleshooting

Check power cord is correctly plugged in
micro
Check the switch on monitor/display unit
Check alignment and pins of connection to the
nanoReel system unit from CCU or display unit.
Check orientation, seating, and pin condition in
Set video source as described in display unit
n a n o
TM
to the European
for Waste Electrical
Solution
the SeeSnake connection.
operator's manual.
Recharge or replace batteries.
Check source setting of monitor and
re seat cable connection.
sales@calcert.com
Guideline
and
English – 15