Toro Groundsmaster 220-D Service Manual page 306

0.34 ± "
0.03
"
0.040 MAX
24
28
Detail A
6. Install clutch assembly onto yoke shaft, then install
other thrust washer. Install retaining ring (Item 23) to
secure clutch assembly to shaft. Install axle coupling
(Item 32) to clutch housing with six (6) capscrews and
lockwashers, then tighten capscrews evenly.
7. Lubricate clutch through grease fitting with No. 2
General Purpose Lithium Grease.
Installing Drive Shaft.
1. Apply never-seize to splines of traction shaft and axle
input shaft.
Repairs
25
Detail B
Arrow end of roller
clutches must face
A
6-bolt f ange end of l
clutch housing
toward rear axle)
27
Figure 9
2. Slide clutch end of drive shaft onto rear axle shaft
spline, aligning roll pin hole in shaft with hole in axle
coupling. Install roll pin (Item 29) through coupling and
shaft.
3. Tighten two (2) capscrews (Item 35) and locknuts
(Item 31) to secure coupling to shaft.
4. Secure drive shaft yoke flange to flange on front axle
differential with six (6) socekt head capscrews and
lockwashers (not shown).
Page 14 - 6 Rev. B
23 32
24 30
B
Apply
Never-seeze
B
25
26 34
Groundsmaster
29
®
223-D