Installing touchpad buttons board
1. Insert the touchpad buttons board into the slot to align the tabs with the grooves on the computer.
2. Tighten the M2.0 x 2.5 screws to secure the touchpad buttons board to the computer.
3. Connect the touchpad buttons board cable to the connector on the touchpad board.
4. Affix the smart card cable and connect it to the connector on the computer.
5. Install the speaker.
6. Connect the battery cable to the connector on the system board.
7. Install the
base
cover.
8. Follow the procedure in
Display Assembly
Removing display assembly
1. Follow the procedure in
2. Remove the
base
cover.
3. Disconnect the battery cable from the connector on the system board.
4. Remove the
WLAN
card.
5. Remove the
WWAN
card.
NOTE:
To identify the number of screws, see
6. To remove the display assembly:
After working inside your
Before working inside your
computer.
computer.
screw list
Disassembly and reassembly
29