Notes
Unfold and load presorted items
■
of laundry. Mix large and small
items. Washing items of different
size distribute themselves better
during the spin cycle. Individual
items of washing may cause
an unbalanced load.
Observe the maximum specified
■
load. Overfilling adversely affects the
washing result and promotes
creasing.
Measuring and adding
detergent and care products
For the majority of programs on your
appliance, detergent and fabric softener
are dispensed automatically; it is a
factory setting for these programs and
can be changed.
~ "Automatic dosing" on page 35
For programs without intelligent dosing,
or if you wish to control the dosing
yourself (in which case, deactivate
intelligent dosing), you will need to add
detergent manually to the manual
dosing compartment.
~ "Manual dosing" on page 38
Starting the programme
Touch and hold Start/Reload A button
for 1~2 seconds, then release the
button. The programme starts and the
appliance door is locked.
The finish-in time is shown in the display
panel and counts down until the
programme starts. After the programme
has started, the programme duration is
displayed. And the symbols for the
programme progress are lighting up.
Operating the appliance
Childproof lock
You can lock the appliance to prevent
the settings you have set from being
changed inadvertently. To do this,
activate the childproof lock.
To activate the childproof lock:
After the programme starts, Touch and
hold the p Easy Iron and ñ Finished
in buttons for 3 seconds. The symbol E
lights up in the display panel.
E lights up: The childproof lock is
■
activated.
E flashes: If the programme and
■
programme settings are adjusted
while childproof lock is activated.
When the programme ends, End
Note:
is displayed. The door is unlocked. E
symbol remain on to remind you to
deactivate the childproof lock.
To deactivate the childproof lock:
Touch and hold the p Easy Iron and
ñ Finished in buttons until the symbol
E disappears.
Adding/removing laundry
After starting the programme, you can
add or remove laundry if necessary.
Touch the Start/Reload A button. The
appliance checks whether reloading is
possible.
If the following appears on the display
panel:
The symbol Õ disappears,
■
reloading is possible.
The symbol Õ lights up, reloading is
■
not possible.
To continue the programme, touch the
Start/Reload A button. The
programme continues automatically.
en
33