EasyPro LED11WW Instructions For Operation

Underwater LED Light Strips
Warm White: LED11WW • LED23WW • LED35WW
Instructions for Operation • Safety • Warranty
Thank you for purchasing an EasyPro LED light strip. With this LED light you can
illuminate a pond or waterfall, highlight a deck or patio and extend the enjoyment of your
entire landscape in the evening hours. This light is fully submersible and may be used in
or out of water (fresh water only).
Maximum Watts
Safety and Electrical Connections
1. Always disconnect the electrical supply before handling, maintaining, repairing or
installing any pond equipment.
2.
3. Never connect the lights directly to a 110 volt or higher outlet.
4. Not for use in swimming pools, hot tubs or bath tubs
5. Connect the transformer to a 110 volt receptacle that is protected by a Ground Fault
Circuit Interrupter.
6. Do not modify wiring in any way, quick plug ends must stay intact and should not be
replaced with terminals. DO NOT modify the white antenna on the control module.
Do not submerge control module.
7. All electrical work must be performed by a qualified technician. Always follow the
National Electrical Code (NEC) or the Canadian Electrical Code as well as all local,
state and provincial codes. Failure to follow manufacturer's installation instructions
may result in electrical shock, fire hazard, personal injury or death, damaged
equipment, provide unsatisfactory performance and will void manufacturer's warranty.
Installation of LED Light Strip
1. Before installing the product check for damaged or missing parts. Contact EasyPro
immediately if pieces are missing or damaged.
2. Be sure the power is disconnected before installing the lights.
3. Determine desired location to place the LED strip.
Note: Be sure to consider that individual diodes cannot be replaced at the end of their
life. Permanent settings may not be the best option in the case that the entire LED
strip must be replaced.
4. Place the LED strip in desired location and secure. Anchor points on both ends of
Blue: LED11CB • LED23CB • LED35CB
11" - 1.75 watts • 23" - 3.5 watts • 35" - 9 watts
Light(s) must be attached to a 12 volt AC UL listed transformer.