Recalling Memories - Yaesu FTM-100DR/DE Operating Manual

Using the Memory
3
Press and hold
The MEMORY WRITE screen appears.
The frequency automatically appears on an empty
memory channel.
Tips • For details on how to assigning a nametag to a memory
channel, see steps 4 to 12 in "Naming a memory
channel" on page 56.
• To specify a specific memory channel, follow step 4 in
"Specifying memory channels" on page 66.
• To set memory channels to skip, follow step 4 in
"Setting memories to skip" on page 67.
4
Rotate the DIAL to select the desired memory
channel.
Tip
Pressing
in steps of 100 memory channels.
5
Press .
Completes memory registration and displays the
frequency and the memory channel number on the
screen.
Tips • The frequency which has been registered to a memory
channel can be overwritten with a new frequency.
• Press
Tips
• When shipped from the factory, the frequency in memory channel 1 of A-band is set to 144.000
MHz whereas the frequency in memory channel 1 of B-band is set to 430.000 MHz. These can be
changed to other frequencies but cannot be erased.
• Names can also be assigned to the memory channels. See "Naming a memory channel" on page
56.
• 9 pairs of PMS memory channels can be written for the A-band and B-band each. See "Scanning
the programmable memories (PMS)" on page 68.

Recalling memories

1
Press .
Switches to memory mode. The most recently used
memory channel appears on the screen.
52
for over one second.
briefly each time skips memory channels
to return to VFO mode.