Managing the Projector from a Remote Computer
78
Connecting and Configuring the
Projector
Before using the Easy Management software to manage your
projector(s), you have to connect each projector you want to monitor
to your network and configure it with an appropriate IP address.
1. Connect the projector to your network using a commercially
available 100baseTX or 10baseT network cable.
Connect the cable to the Ethernet port on the projector as shown.
Ethernet port
2. Turn on the projector (see page 28).
3. Press the
button on the remote control and select
Menu
from the
Advanced2
Video
Video
Brightness Control
Brightness Control
Audio
Audio
Projector ID
Projector ID
Effect
Effect
Network
Network
Setting
Setting
COM Port
COM Port
User's Logo
User's Logo
Auto setup
Auto setup
Advanced1
Advanced1
BNC Sync Termination
BNC Sync Termination
Advanced2
Advanced2
Reset
Reset
About
About
Reset All
Reset All
[
[
]: Select
]: Select
[
[
]: Enter
]: Enter
4. If your network assigns addresses automatically, turn on
menu.
:
High
High
Low
Low
: 1
: 1
Set
Set
Set
Set
:
RS-232C
RS-232C
USB
USB
:
ON
ON OFF
OFF
:
ON
ON OFF
OFF
Execute
Execute
[Menu]: Exit
[Menu]: Exit
Network
Select Network
.
DHCP