Epson PowerLite 7800p User Manual page 87

5. If your network does not assign addresses automatically, turn off
and enter the projector's
DHCP
Gateway Address
■ To enter numbers using the remote control, press the
button until it lights, then use the number keypad shown
below.
Num button
■ To change the network addresses from the projector's control
panel, press the right and left arrow buttons to select the part
of the address you want to enter, then use the up and down
arrow buttons to increase or decrease the numeric value.
Select the
part of the
address to
change
When you finish changing an address in the network menu, press
the button (on the remote control) or the
Enter
button (on the projector). This stores the value.
6. When done making all necessary changes, press
menu system.
IP Address
, and , as needed.
MAC Address
Zero
Increase
or
decrease
the value
Managing the Projector from a Remote Computer
, ,
Subnet Mask
Num
Auto/Enter
to exit the
ESC
note
If you're a network
administrator, you can use
the option to enter a
SNMP
trap IP address. This lets you
receive trap alerts for the
projectors you're monitoring.
If you have HP OpenView,
a plug-in will be available
to allow you to manage your
projectors in HP OpenView.
Check with your dealer or
EPSON for availability (see
page 113).
79