Miele SmartLine CS 7612 Operating And Installation Instructions page 67

Installing the SmartLine element
 Stick the supplied sealing strip under
the edge of the SmartLine element.
Do not apply the sealing strip under
tension.
 Feed the mains connection cable
down through the worktop cutout.
 Position the SmartLine element in the
worktop cutout. Ensure that:
- The seal of the appliance sits flush
with the worktop on all sides to en-
sure an effective seal all round.
- All gap widths are uniform.
 If the seal does not meet the worktop
correctly on the corners, carefully
scribe the corner radii (≤ R4) with a
jigsaw.
Do not use any additional sealant
(e.g. silicone) on the SmartLine ele-
ment.
 Connect the SmartLine element to
the mains electricity supply.
 If required, connect the SmartLine
element to the gas supply (see "In-
stallation – Gas connection").
 Check that the SmartLine element
works.
 Seal the gaps between the individual
elements with a silicone sealant that
is heat-resistant to at least 160 °C.
Unsuitable sealant can damage nat-
ural stone.
For natural stone worktops and nat-
ural stone tiles, only use silicone
sealant that is specially formulated
for natural stone. Follow the manu-
facturer's instructions.
Installation
67