Sharp AN-K2LP Operation Manual page 16

4.
Select the INPUT mode
Select the "INPUT 3" using the INPUT button on the projector or the INPUT 3 button on the remote control.
On the On the remote
projector control
• • • • • When pressing on the projector, input mode switches in order of :
INPUT 1 INPUT 2 INPUT 3
• • • • • When using the remote control, press
5.
Turn the video equipment on and playback
6.
Adjust the projector angle, focus and zoom
1
Adjust the focus
On the projector
1 Press .
2 Adjust the focus by pressing \ or |.
2
Adjust the projected image size by adjusting zoom.
On the projector
1 Press .
2 Adjust the zoom by pressing ' or ".
7.
Correct trapezoidal distortion
Correcting trapezoidal distortion using the Keystone Correction
On the remote control
Select "H Keystone"
or "V Keystone".
8.
Turn the Power off
Press the STANDBY button, then press that button again while the confirmation message is displayed, to put
the projector into standby mode.
On the projector
• • • • • Unplug the power cord from the AC outlet after the cooling fan stops.
" " " " " On-screen Display
INPUT 4 INPUT 5 DIGITAL
/ /
On the remote control
1 Press .
2 Adjust the focus by pressing \ or |.
On the remote control
1 Press .
2 Adjust the zoom by pressing ' or ".
Adjust
On the remote control
/ / / to switch the INPUT mode.
3
Adjust the projector angle
using the HEIGHT ADJUST
button.
Horizontal
" " On-screen Display " " "
Page 29
HEIGHT ADJUST
button
Pages 30, 31
Vertical
Pages 32, 33
Page 28
-15