Turntable Motor; Steam Sensor (Only For Sensor Models) - Panasonic NN-ST681S Service Manual

NN-SD691S / NN-ST681S / NN-SD671S / NN-ST671S / NN-ST661S / NN-ST661B / NN-ST661W / NN-ST651B / NN-ST651W
4.6.

Turntable motor

1. Remove the motor cover by breaking off at the 8 spots
indicated by arrows with a cutter or the like.
NOTE:
After removing the motor cover, be sure that cut
portions are properly trimmed or bent to the inside
so that no sharp edges will be exposed to outside.
2. Disconnect 2 lead wires connected to the turntable motor.
3. Remove the turntable motor by removing screw.
NOTE:
After reinstalling the new turntable motor and
reconnecting the 2 lead wires, reinstall the motor
cover by rotating it around 180, tucking the 2 tabs
under the base in the 2 provided slots, then screw
the single tab to the base using a 4mm × 6mm
screw.
4.7. Steam sensor (Only for sensor
models)
1. Disconnect connector CN2 from digital programmer circuit
board.
2. Disengage catch hooks on sensor cover C from orifice.
3. Remove steam sensor from orifice.
NOTE:
When installing the steam sensor, make sure that
the direction of steam sensor is as shown in figure.
14