InFocus ScreenPlay 7205 Service Manual page 48

4 Unplug the lamp blower contact ECA cable and the speaker cable from their connectors on the
controller ECA. Then disconnect the keypad cable from the ZIF connector on the controller ECA.
5 If you are going to replace the top case with a new one, remove the elevator button. To do this,
use a small flat blade screwdriver to depress the retainer tab on the side of the elevator button.
Then slide the button out of the top case.
Assembly Notes
•
If you're replacing the top case with a new one, install the elevator button.
•
Adhere a new nameplate to the top case in the recess near the handle.
•
Connect the keypad lamp blower contact ECA cable, the speaker cable and the keypad cable.
•
Make sure that the top case fits flush over the bottom case.
•
Torque the two black M3x8 Torx screws to 6 in.-lbs. (.678 Nm).
SP7205 Service Manual 48