Installing Cables - Huawei BTS3902E WCDMA Installation Manual

BTS3902E WCDMA
Installation Guide
About This Chapter
This chapter describes the procedure and precautions for installing the PGND cables, power
cables, and transmission cables for a BTS3902E in various scenarios. Based on actual
requirements, and it also describes how to install an optional monitoring signal cable as required.
9.1 Cabling Requirements
Cables must be routed according to the specified cabling requirements to prevent signal
interference.
9.2 Cable Connections
The cable connections of the BTS3902E vary depending on the number of BTS3902Es and the
BTS3902E port.
9.3 Installing a PGND Cable and Equipotential Cable
The protection ground (PGND) cable and equipotential cable must be installed based on actual
requirements.
9.4 Installing a BTS3902E Power Cable
A BTS3902E power cable connects the BTS3902E to an external power device, feeding external
power into the BTS3902E.
9.5 (Optional) Installing a BTS3902E RF Jumper
You must install a radio frequency (RF) jumper when a BTS3902E uses an external antenna.
9.6 Installing Transmission Cables
When a BTS3902E is installed outdoors, a fast Ethernet or gigabit Ethernet (FE/GE) cable or
FE/GE fiber optic cable must be installed based on actual requirements.
9.7 Installing the Housing
This chapter describes the procedures for installing the upper housing and optional camouflage
shell for a BTS3902E after the BTS3902E and related cables are installed.
9.8 Checking the BTS3902E Hardware Installation
This chapter describes how to check the hardware installation after a BTS3902E is installed.
9.9 Performing a Power-On Check on the BTS3902E
This chapter describes the procedure for performing a power-on check on the BTS3902E.
9.10 Appendix
Issue Draft A (2011-06-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9

Installing Cables

9 Installing Cables
9-1