Barco С 5010S User Manual page 21

FCC RF Radiation Exposure Statement: This device is capable of operating in 802.11a mode. For 802.11a
devices operating in the frequency range of 5.15 - 5.25 GHz, they are restricted for indoor operations to
reduce any potential harmful interference for Mobile Satellite Services (MSS) in the US. WIFI Access Points
that are capable of allowing your device to operate in 802.11a mode (5 .15 - 5.25 GHz band) are optimized for
indoor use only. If your WIFI network is capable of operating in this mode, please restrict your WIFI use
indoors to not violate federal regulations to protect Mobile Satellite Services.
1. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
2. This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20 cm between the radiator
and your body.
Base Unit FCC ID: 2AAED-R9861521
Button FCC ID (model R9861600D01C): 2AAED-R9861600D01
ClickShare Button 2AAED-R9861600D01 has been tested and meets the FCC RF exposure guidelines.The
maximum SAR value reported is 1.19 W/kg.
ClickShare button 2AAED-R9861600D01 should be installed and operated with a minimum distance of 5 mm
between the radiator and your body.
Canada, Industry Canada (IC) Notices
This device complies with Industry Canada licence-exempt RSS standard (s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Radio Frequency (RF) Exposure Information
The radiated output power of the Barco Wireless Device is below the Industry Canada (IC) radio frequency
exposure limits. The Barco Wireless Device should be used in such a manner such that the potential for
human contact during normal operation is minimized.
Caution: Exposure to Radio Frequency Radiation.
1. To comply with the Canadian RF exposure compliance requirements, this device and its antenna must not
be co-located or operating in conjunction with any other antenna or transmitter.
2. To comply with RSS 102 RF exposure compliance requirements, a separation distance of at least 20 cm
must be maintained between the antenna of this device and all persons.
Base Unit IC: IC: 21559-R9861521
Button IC (model R9861600D01C): 21559-R9861600D01
IC Antenna statement
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that necessary for successful communication.
This radio transmitter 21559-R9861521 has been approved by Industry Canada to operate with the antenna
types listed below with the maximum permissible gain and required antenna impedance for each antenna type
indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for
that type, are strictly prohibited for use with this device.
Indoor use only warning
Operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to
co-channel mobile satellite systems.
Certification information (SAR)
This device is also designed to meet the requirements for exposure to radio waves established by the Industry
Canada.
The SAR limit adopted by Canada is 1.6 W/kg averaged over one gram of tissue. The highest SAR value
reported to the IC for this device type complies with this limit.