Dimmer Operation - Jensen JBS-215 User Manual

Wall mountable bluetooth music system with cd
Hide thumbs Also See for JBS-215:
Table of Contents

Advertisement

This unit provides 5 different EQ modes to enhance your listening experience. You can select
the desired effect by tapping the EQ Button (#9) on the top of the main unit or on the remote
repeatedly.
Note: There is no indication on the display when the EQ set to FLAT.
Press and hold the SLEEP/DIMMER BUTTON (#2) to change the display brightness. There are
3 brightness levels available (Low, Mid or High).
CHARGING YOUR SMART PHONE OR PORTABLE DEVICE
This unit features a 1 AMP USB port located on the back of the unit (next to the power jack) for
charging your portable device (iPod, iPhone, Android phone, etc.) when used with the USB
charging cord (not included).
1.
Plug one end of the USB cable (not included) into the USB Charging Port on the back of the
unit, and plug the other end of the cord into the device you wish to charge.
2.
Observe the battery charge indicator on your device to make sure the charging process
starts normally.
3.
Unplug the cable when your device is fully charged.
CAUTION:
Before charging, please refer to the user manual of the device you wish to charge to make sure
the charging current requested does not exceed 1A (1000mA). Overloading the charging circuit
may damage the unit permanently and void the warranty.
1.
The USB charging port of this unit supplies a DC 5V output at 1000 mA maximum current
to charge your smart phone or portable device battery and it cannot support any other
voltage range.
2.
Make sure the device you want to charge has a battery charge rating of DC 5V only.
3.
The USB port of this unit is designed for smart phone or portable device battery charging
only and it cannot support data transfer or connect to computer.
4.
Do not connect the USB port of this unit to other external power charger USB ports, it may
damage both units and void the warranty.
Notes:
1.) Some smart phones and portable devices use proprietary USB connections and circuitry, so
they may not charge when plugged into the USB port. Please refer to your device user
manual before you attempt to charge them.
2.) It is normal if the unit gets warm while the USB port is in use and charging your smart phone
or portable device.
3.) Do not charge your smart phone over 12 hours continuously. Disconnect your smart phone
or other portable device from the USB cord once it is fully charged.
FLAT
ROCK

DIMMER OPERATION

PRESET EQ
CLASSIC
E-15
JAZZ
POP

Advertisement

Table of Contents
loading

Table of Contents