Huawei AP4050DN-E Hardware Installation And Maintenance Manual page 56

AP4050DN-E
Hardware Installation and Maintenance Guide
Figure 5-22 Components of an OT terminal and a power cable
A. Heat-shrinkable tubing
Procedure
Step 1 Based on the cross-sectional area of the cable conductor, strip a length of insulation coating C
to expose the conductor D of length L1, as shown in
of L1 are listed in
Figure 5-23 Stripping a power cable (OT terminal)
l When you strip a power cable, do not damage the conductor of the cable.
l If the bare crimping terminal is not provided by Huawei, the value of L1 is 1 mm (0.04 in.)
Issue 05 (2018-02-02)
Table 5-2.
NOTICE
to 2 mm (0.08 in.) greater than the value of L.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
B. Bare crimping terminal
Figure
5 Appendix
C. Insulation D. Conductor
5-23. The recommended values
48