Installing Power Adapters; Installing The Ot Terminal - Huawei AP4050DN-E Hardware Installation And Maintenance Manual

AP4050DN-E
Hardware Installation and Maintenance Guide
l
l
Requirements for Cable Routing
l
l
l
l
l
l

5.1.5.2 Installing Power Adapters

5.1.5.2.1 Installing the OT Terminal

Procedure
l
Issue 05 (2018-02-02)
Do not twist, bend, stretch, or extrude fibers during installation.
Cover the idle fiber connectors with dust caps. Remove the dust caps before using the
fiber connectors.
To protect cables, remove the burrs in the cable through-holes or install protective rings
in the holes.
To ease the connection and to avoid stress, keep cable joints slack. After connecting
multiple cables to a connector that has multiple interfaces, keep the cables slack to avoid
generating stress.
Bind or clean cables gently because cable distortion affects signal quality.
Keep cables away from moveable components such as doors.
Sharp objects must not touch cable wiring to prevent damage to cables.
To protect power cables, route power cables of the active and standby power modules
separately.
Install an OT terminal.
a. Align the hole of the OT terminal (conductor upward) with a connecting hole, as
shown in Figure 5-108.
Figure 5-108 Aligning the OT terminal with a connecting hole
NOTE
When you install an OT terminal, the crimping sleeve is installed as shown in
where A is correct and B is incorrect.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Appendix
Figure 5-109,
95