TurboChef plexor Owner's Manual page 25

I ssue Po ssi b l e C a u se( s)
No power to - Oven is not plugged in.
oven. - Main circuit breaker is tripped.
Oven is not - Oven is not clean. (Large
cooking deposits of grease, carbon, or
properly. food debris dilute the
microwave.)
- Incorrect group and/or item name
was selected for the product.
- Product was not cooked from
correct starting state (for
example, chilled or frozen).
- Product out of specification.
F1: Blower - Oven power interrupted.
Running Status
Bad
F2: Cook - Air nozzles on the top/bottom
Temperature of the cook cavity are clogged.
Low - Defective heater.
- Blower motor not running.
- Oven not fully warmed up.
F5: Magnetron - Blockage of cool air into the
Over oven.
Temperature
- Rear filter intakes clogged.
F6: EC Temp - Blockage of cool air into the
oven.
- Rear cooling fan exhaust
guard(s) clogged.
Re s o l u t io n
- Plug the oven in.
- Verify the wall circuit breaker is on. Reset the
breaker, then power the oven back on.
- Clean the oven following the cleaning
instructions on pages 5-6.
- Ensure the correct food group and/or item
was selected.
- Ensure the product was in the correct state
before being placed in the oven.
- Ensure the product is exactly the same weight/size
as the typical product.
- Turn the oven off and unplug the oven –
leave for two minutes. Re-plug in the oven,
switch on the isolator/main power supply, and
try operating the oven.
- During daily cleaning, make sure to unclog the
air nozzles on the top/bottom of the cook cavity.
- Reset the high-limit thermostat located on the oven
rear wall.
- Call Customer Support.
- Repeat preheat and allow the oven to idle for
five minutes.
- Remove anything that may be obstructing
the flow of cool air into the oven panels.
- Make sure the rear filter intakes are free of debris.
- Remove anything that may be obstructing
the flow of cool air into the oven panels.
- Make sure the rear fans are free of debris.
17