Maintenance And Cleaning - Beko WMY 91446HLB1 User Manual

Table of Contents

Advertisement

Available languages

Available languages

4.12 Child Lock
Use Child Lock function to prevent children from
tampering with the machine. Thus you can avoid any
changes in a running programme.
C
You can switch on and off the machine with
/ Off
button when the Child Lock is active. When
you switch on the machine again, programme will
resume from where it has stopped.
When the child lock is enabled, an audio warning
will be given if the buttons are pressed. Audio
warning will be canceled if the buttons are pressed
5 times consecutively.
To activate the Child Lock:
Press and hold Auxiliary Function button 2 for 3
seconds. After the countdown as "CL 3-2-1" on the
display is over, "Child Lock Enabled" appears on the
display. Release 2nd Auxiliary Function button 1
when this warning is displayed.
To deactivate the childproof lock:
Press and hold Auxiliary Function button 2 for 3
seconds. After the countdown as "CL 3-2-1" on the
display is over, "Child Lock Enabled" disappears from
the display.
4.13 Canceling the programme
The programme is cancelled when the machine is
turned off and on again. Press and hold On / Off
button for 3 seconds. After the countdown as "3-2-1"
on the display is over, the machine turns off.
C
On / Off
If you press
enabled, the programme will not be cancelled. You
should cancel the Child Lock first.
If you want to open the loading door after you
have cancelled the programme but it is not possible
to open the loading door since the water level in
the machine is above the loading door opening,
Programme Selection
then turn the
Pump+Spin
programme and discharge the water
in the machine.
4.14 End of programme
End symbol appears on the display when the
programme is completed.
If you do not press any button for 10 minutes, the
machine will switch to OFF mode. Display and all
indicators are turned off.
Completed programme steps will be displayed if you
press On / Off button.
4.15 Adjusting the VOLUME level
Low volume and high volume
Press and hold Auxiliary Function button 3 for
3 seconds to adjust the volume level. After the
countdown as "3-2-1" on the display is over, the
volume level symbol will appear and the new volume
level will be displayed.
42 / EN
On
button when the Child Lock is
knob to

5 Maintenance and cleaning

Service life of the product extends and frequently
faced problems decrease if cleaned at regular intervals.
5.1 Cleaning the detergent drawer
Clean the detergent drawer at regular intervals (every
4-5 washing cycles) as shown below in order to
prevent accumulation of powder detergent in time.
Lift the rear part of the siphon to remove it as
illustrated.
C
If more than normal amount of water and
softener mixture starts to gather in the softener
compartment, clean the siphon.
2 Wash the detergent drawer and the siphon with
plenty of lukewarm water in a washbasin. Wear
protective gloves or use an appropriate brush to
avoid touching of the residues in the drawer with
your skin when cleaning.
3 After cleaning, replace the siphon back to its seating
and push its front section downwards to make sure
that the locking tab engages.
5.2 Cleaning the loading door and the drum
For products with drum cleaning programme, please
see Operating the product - Programmes.
For products without drum cleaning, follow the below
steps to clean the drum:
Select Additional Water or Extra Rinse auxiliary
functions. Use a Cottons programme without
pre-wash. Set the temperature to the level
recommended on the drum cleaning agent which
can be provided from authorized services. Apply
this procedure without any laundry in the product.
Before starting the programme, put 1 pouch of special
drum cleaning agent (if the special agent could not be
supplied, put max. 100 g of powder anti-limescale) into
the main wash detergent compartment (compartment
no. "2"). If the anti-limescale is in tablet form, put only
one tablet into the main wash compartment no. "2".
Dry the inside of the bellow with a clean piece of cloth
after the programme has come to an end.
C
Repeat Drum Cleaning process in every 2 months.
Use an anti-limescale suitable for the washing
machines.
After every washing check that no foreign substance is
left in the drum.
Washing Machine / User's Manual

Advertisement

Table of Contents
loading

Table of Contents