Disposing Of The Waste Product; Compliance With Weee Directive - Beko WMY 91446HLB1 User Manual

1.5 Disposing of the waste product

• This product has been manufactured with high quality parts and materials which
can be reused and are suitable for recycling. Therefore, do not dispose the product
with normal domestic waste at the end of its service life. Take it to a collection
point for the recycling of electrical and electronic equipment. Please consult your
local authorities to learn the nearest collection point. Help protect the environ-
ment and natural resources by recycling used products. For children' s safety, cut
the power cable and break the locking mechanism of the loading door so that it
will be non-functional before disposing of the product.

1.6 Compliance with WEEE Directive

This product complies with EU WEEE Directive (2012/19/EU). This product
bears a classification symbol for waste electrical and electronic equipment
(WEEE).
This product has been manufactured with high quality parts and materials
which can be reused and are suitable for recycling. Do not dispose of the
waste product with normal domestic and other wastes at the end of its
service life. Take it to the collection center for the recycling of electrical
and electronic equipment. Please consult your local authorities to learn
about these collection centers.
Compliance with roHS Directive:
The product you have purchased complies with EU RoHS Directive (2011/65/EU). It
does not contain harmful and prohibited materials specified in the Directive.
2 Installation
Refer to the nearest Authorised Service Agent for
installation of the product. To make the product ready
for use, review the information in the user manual
and make sure that the electricity, tap water supply
and water drainage systems are appropriate before
calling the Authorized Service Agent. If they are not,
call a qualified technician and plumber to have any
necessary arrangements carried out.
C
Preparation of the location and electrical, tap
water and waste water installations at the place of
installation is under customer' s responsibility.
Make sure that the water inlet and discharge
hoses as well as the power cable are not folded,
pinched or crushed while pushing the product into
its place after installation or cleaning procedures.
B
WArNINg:
Installation and electrical
connections of the product must be carried out by
the Authorized Service Agent. Manufacturer shall
not be held liable for damages that may arise from
procedures carried out by unauthorized persons.
A
WArNINg:
Prior to installation, visually check
if the product has any defects on it. If so, do not
have it installed. Damaged products cause risks for
your safety.
2.1 Appropriate installation location
• Place the machine on a rigid floor. Do not place it on
a long pile rug or similar surfaces.
• Total weight of the washing machine and the dryer
-with full load- when they are placed on top of each
29 / EN
other reaches to approx. 180 kilograms. Place the
product on a solid and flat floor that has sufficient
load carrying capacity!
• Do not place the product on the power cable.
• Do not install the product at places where
temperature may fall below 0ºC.
• Place the product at least 1 cm away from the edges
of other furniture.
2.2 removing packaging reinforcement
Tilt the machine backwards to remove the packaging
reinforcement. Remove the packaging reinforcement
by pulling the ribbon.
Washing Machine / User's Manual