Alarms - Smeg CVIA118RN2 Manual

3.7 Alarms

The alarms help protect the wine
from temperatures which could
compromise its quality.
Each alarm consists of a message flashing
on the display, the Alarm
lighting up and an audible warning.
The display continues to flash until the alarm
condition finishes.
• To deactivate the alarm, press the Alarm
button.
Temperature alarm
The temperature on the display may start to
flash. This means that the temperature inside
the wine cellar compartment is too high or
too low in relation to that set.
This may occur:
• when the appliance is first turned on;
• if a temperature much higher or much
lower than the previous one is set;
• if the wine cellar is loaded with many
bottles at ambient temperature;
• in the event of an extended interruption
in mains voltage.
18
Use
These conditions may occur during normal
operations of the appliance and are not
caused by problems/faults.
In this case, deactivate the alarm with the
Alarm
temperature to return within the normal
storage values. It may be necessary to
button
repeat this operation 1–2 times.
Alarm for door open
The display shows
been left open for more than 60 seconds
• Close the door.
Fault alarms
The display shows from
(
• Switch off the appliance and call
button and wait for the
If the alarm continues to occur, call
Technical Support.
The alarm will reactivate in the
same way 60 seconds after it is
shut off if the door is still open.
excluded) or
or : appliance fault.
Technical Support.
: the door has
to
or or