Related Manuals for Smeg SCV115-1
Summary of Contents for Smeg SCV115-1
- Page 1 MANUALE D’USO INSTRUCTION MANUAL MANUEL D'UTILISATION GEBRAUCHSANWEISUNG CANTINA WINE CELLAR CAVE À VIN WEINKÜHLSCHRANK...
-
Page 2: Table Of Contents
9.5 Identifying and Dealing with Malfunctions..................... 32 10. SOME HINTS FOR SAVING MONEY ................. 34 INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified engineer who is to install, commission and test the appliance INSTRUCTIONS FOR THE USER: these provide recommendations for use, a description of the controls... -
Page 3: The Environment - Disposal Instructions
PROPERLY. CONTACT YOUR LOCAL DEALER OR THE COMPETENT LOCAL ORGANISATIONS FOR THE ADDRESSES OF COLLECTION, RECYCLING AND DISPOSAL FACILITIES. NEVER LEAVE ALL OR PARTS OF THE PACKAGING LYING AROUND: PACKAGING PARTS, AND ESPECIALLY PLASTIC BAGS, MAY REPRESENT A SUFFOCATION HAZARD FOR CHILDREN. -
Page 4: Precautions For Use
TEMPERATURE INSIDE THE APPLIANCE WHICH MIGHT LEAD DETERIORATION OF THE WINE'S CONDITION. The manufacturer declines all responsibility for injury or damage caused by failure to comply with the above regulations or deriving from tampering with even just one part of the appliance and the use of non- original spare parts. -
Page 5: Safety Precautions
IN CASE OF MALFUNCTIONS, DISCONNECT THE APPLIANCE FROM THE POWER SUPPLY BY REMOVING THE PLUG, WITHOUT PULLING ON THE POWER SUPPLY LEAD. ALL REPAIRS OR OTHER WORK NOT COVERED BY THIS MANUAL MUST BE CARRIED OUT BY A QUALIFIED ENGINEER, TO BE FOUND AT AN AUTHORISED SERVICE CENTRE. NEVER ATTEMPT TO REPAIR THE APPLIANCE YOURSELF. -
Page 6: Installation And Connection
To allow proper cooling of the condenser, the wine cellar must not be placed too close to the wall. Leave a gap of at least 5 cm between the back of the appliance and the wall. There must be an opening of at least 200 cm behind the wine cellar. -
Page 7: Positioning And Levelling The Appliance
The appliance is able to withstand brief voltage fluctuations of not more than 15% below or 10% above the rated value. If the power supply lead has to be replaced, this operation must only be carried out by an authorised Smeg technical service engineer. -
Page 8: Getting To Know Your Appliance
The inside of the appliance should be cleaned to remove all manufacturing residues. For further information about cleaning, see “9. Cleaning and maintenance”. On first use or after a lengthy power blackout, the appliance should be run for about 2 hours before bottles are placed inside. -
Page 9: Operation
After approx. 3 seconds “Pon” flashes in the display, and the temperature can be set. 7.4 Temperature setting at the top of the appliance Push SET1. Then the temperature at the top of the appliance can be adjusted up and down by means of the “up and down” buttons. -
Page 10: Low-Temperature Alarm
7.7 Storage Temperatures As you will certainly already know, to enjoy the flavour and bouquet of each wine at its best, it should be stored and drunk at a specific temperature. The following table lists these temperatures in relation to the type of wine. - Page 11 7.7.4 Sparkling wines In view of large number of types of sparkling wines on the market, there would be little sense in laying down one rule to fit them all. Sweet, aromatic white sparkling wines can be served at a temperature as low as 8°C;...
-
Page 12: Filling The Cellar With Bottles
Wines in the bottle must always be stored out of their original packaging (boxes or crates); Once opened, bottles must be placed so that the wine covers the whole of the cork. There must be no air between the cork and the liquid;... -
Page 13: Accessories
Leave the door ajar to prevent the humidity and trapped air from creating unpleasant smells. The appliance should not be left unattended for more than 3-4 days. If you are to be away for some time, it is best to switch the wine cellar off. -
Page 14: Operating Noises
Other normal wine cellar operating noises are a gurgling and a rustling due to the refrigerant flowing through the pipes in the circuit. These noises are perfectly normal and do not mean that the appliance is malfunctioning. If they are over-loud, there may be other causes. -
Page 15: Identifying And Dealing With Malfunctions
9.5 Identifying and Dealing with Malfunctions Your new wine cellar has been designed and built to strict quality standards. This section is intended to enable you to identify the origin of any malfunctions which may occur before contacting your local authorised After-Sales Service. - Page 16 TELEPHONE DIRECTORY. WHEN CONTACTING THE AFTER-SALES SERVICE, PLEASE BE READY TO INFORM OUR CALL SERVICE OPERATORS CLEARLY OF THE MODEL OF THE PRODUCT YOU HAVE PURCHASED AND THE SERIAL NUMBER MARKED ON THE NAMEPLATE INSIDE THE BODY OF THE WINE CELLAR.
-
Page 17: Some Hints For Saving Money
The layer of dust which forms disperses the low temperature and considerably increases power consumption. 8 If the wine cellar is to be out of use for a long period, it is best to empty it and switch it off.