Timer Control; Sleep Mode Operation; Random Auto Restart Control - Panasonic CS-BE35TKE Service Manual

12.5 Timer Control


There are 2 sets of ON and OFF timer available to turn the unit ON or OFF at different preset time.

If more than one timer had been set, the upcoming timer will be displayed and will activate in sequence.
12.5.1 ON Timer Control

ON timer 1 and ON timer 2 can be set using remote control, the unit with timer set will start operate earlier than
the setting time.
This is to provide a comfortable environment when reaching the set ON time.

60 minutes before the set time, indoor (at fan speed of Lo-) and outdoor fan motor start operate for 30 seconds to
determine the indoor intake air temperature and outdoor air temperature in order to judge the operation starting
time.

From the above judgment, the decided operation will start operate earlier than the set time as shown below.
12.5.2 OFF Timer Control
OFF timer 1 and OFF timer 2 can be set using remote control, the unit with timer set will stop operate at set time.

12.6 Sleep Mode Operation

SLEEP
To maximise comfort while sleeping
(CANCEL)

This operation provides you with a comfortable environment while sleeping. It will automatically adjust the sleep
pattern temperature during the activation period.

The indoor unit indicator will dim when this operation is activated. This is not applicable if the indicator brightness
has been manually dimmed.

This operation is incorporated with the activation timer (0.5, 1, 2, 3, 4, 5, 6, 7, 8 or 9 hours).

This operation can be set together with single timer or twin timer. Sleep operation has the priority over OFF timer.

This operation can be cancelled by pressing the respective button when the sleep timer reaches 0.0h.

12.7 Random Auto Restart Control


When the power supply is cut off during the operation of air conditioner, the compressor will re-operate within
three to four minutes (there are 10 patterns between 2 minutes 58 seconds and 3 minutes 52 seconds to be
selected randomly) after power supply resumes.

This type of control is not applicable during ON/OFF Timer setting.

This control can be omitted by open the circuit of JP1 at indoor unit printed circuit board.
49