JVC KD-G111 Service Manual page 11

3.2.2 Removing the connector board
(See Figs.3 to 5)
CAUTION:
Before disconnecting the flexible wire from the pickup, solder
the short-circuit point on the pickup. No observance of this in-
struction may cause damage of the pickup.
(1) Remove the screw B fixing the connector board.
(2) Solder the short-circuit point on the connector board.
(3) Disconnect the flexible wire from the pickup.
(4) Move the connector board in the direction of the arrow to
release the two joints b.
(5) Unsolder the wire on the connector board if necessary.
CAUTION:
Unsolder the short-circuit point after reassembling.
Wires
B
Connector board
Joints b
Fig.3
Flexible wire
Fig.4
Connector board
Flexible wire
Frame
Fig.5
Pickup
Short-circuit point
Short-circuit point
(Soldering)
Pickup
B
(No.MA125)1-11