Checking Transaxle Fluid Level; Checking Dial Cam Rotation Force; Checking Movable Parts - Kubota Z724X Operator's Manual

BChecking Transaxle Fluid Level
1. Park the machine on a flat surface, lower the
implement to the ground and shut off the engine and
remove the key.
2. Check to see that the oil level lies between the "MAX"
and "MIN" lines while the machine and oil are at
ambient temperature.
If the level is too low, add the new oil to the prescribed
level into the expansion tank.
(See "LUBRICANTS AND FUEL" in "MAINTENANCE"
section.)
3. Do not overfill past "MAX" line.
Oil expands with heat and may leak from cap during
usage if overfilled.
(1) Transaxle fluid expansion tank
A If oil level is low, do not run engine.
Add the new oil to the prescribed level into the
expansion tank.
A Do not overfill the expansion tank.
BChecking Dial Cam Rotation Force
1. Park the machine on a flat surface, shut off the engine
2. Raise the implement to the "TRANSPORT" position.
3. Rotate the cutting height control dial and check for
4. If rotation force is too high, clean dial cam area and
(1) Dial cam
(2) Frame surface
(A) MAX line
BChecking Movable Parts
(B) MIN line
If any of the movable parts, such as levers and pedals, is
not smoothly moved because of rust or sticky material, do
not attempt to force it into motion.
In the above case, remove the rust or the sticky material,
and apply oil or grease on the relevant spot.
Otherwise, the machine may get damaged.
PERIODIC SERVICE
and remove the key.
(See "ADJUSTING CUTTING
"OPERATING THE MOWER" section.)
smoothness.
apply grease under the dial cam between the dial cam
and frame.
(R) "ROTATE"
43
HEIGHT" in