Morphy Richards Storm 73215 Instruction Booklet page 6

VC73215MUK Rev5_Instruction Booklet 22/09/2011 09:20 Page 6
F
G
H
I
J
K
6 UK Helpline 0844 871 0960
MAINTENANCE
DUST CANISTER
Emptying
To obtain the best results from
your cleaner, empty the dust
canister ‡ regularly, otherwise
the airflow and cleaning power
will be reduced.
1 Disconnect the cleaner from the
mains socket.
2 Disconnect the hose from the
cleaner.
Remove the dust canister ‡
3
from the cleaner by pushing the
release latch ⁄ F.
4 Take the dust canister to the bin.
5 By using the click-to-clean
feature Ú, rotate the pleated
filter inside the mesh filter to
shake loose the dust G.
Raise the filter assembly Ï
6
handle then lift out the filter
assembly from the dust canister
‡ H and put to one side.
7 Empty the dust canister into the
bin.
8 Place the dust canister safely to
one side.
9 Clean the filters as described
overleaf.
10 Reassemble.
ALLERGY
SUFFERERS
When emptying any vacuum
cleaner, it is difficult to avoid
exposure to dust. To minimise
this risk, please ensure that you
encase the dust canister in a
large bag to empty it. Close the
bag as tightly as possible round
the dust canister. Remove the
dust canister and close the bag
as tightly and quickly as
possible and dispose of this
immediately. It is advisable to
wear disposable gloves and a
face mask while emptying the
cleaner. If at all possible, ask a
non allergy sufferer to empty the
dust canister when required.
Replacement Parts 0844 873 0726
FILTERS
All filters must be checked and,
if necessary, cleaned every time
the dust canister is emptied.
To clean the filters, shake or
brush them over a dustbin. The
filters may also be washed but
must be left to thoroughly air
dry before re-use.
IMPORTANT: Do not wash filters
with detergents.
IMPORTANT: Do not use heated
appliances to dry filters.
IMPORTANT: Never use the
appliance without the filters
installed, otherwise damage
may occur which would not be
covered by the guarantee.
Cleaning the canister
filter
Use the small brush Ô provided
1
(located on the filter assembly)
to remove any fluff from the
outside of the mesh filter I.
Rotate the mesh filter Ó
2
clockwise to release the mesh
filter and pleated filter Ì
assembly from the filter holder J.
Lift out the pleated filter Ì and
3
clean it (see 'Filters' for more
information).
4 Re-assemble the filter assembly
by placing the pleated filter
inside the mesh filter, then place
the filter holder on top in the
correct position. Rotate the
mesh filter assembly
anti-clockwise to lock the
assembly together K.
5 Place the filter assembly back
inside the dust canister, making
sure the filter assembly is
placed level and that the filter
holder seal is seated neatly.
6 Re-attach the dust canister to
the cleaner by hooking the
bottom of the dust canister in
first, then closing the canister
until it clicks and the canister
release catch ⁄ is fully down
and secured L.
Ireland Helpline 1800 409 119