Table of Contents
Advertisement
HCD-XG60/XG500
[Aging Mode]
This mode can be used for operation check of tape deck section.
Tape deck section work in parallel.
• If an error occurred:
The aging operation stops and display then status.
• If no error occurs:
The aging operation continues repeatedly.
Procedure:
1. Load the tapes into the decks A and B respectively.
[FUNCTION]
2. Press the
button to select the function "CD".
[PLAY MODE]
3. Press the
button to set the "ALL DISCS" mode,
[REPEAT]
and press the
button to "REPEAT" off.
[
/CLOCK SET]
4. Press three buttons of
c
[DISC 4]
and
simultaneously.
5. The aging mode is activated, if the indicator of disc tray num-
ber on the fluorescent indicator tube is blinking.
6. To release from the aging mode, press the
the power OFF and operate the cold reset. (Refer to the "MC
Cold Reset")
1. Display at the Aging Mode
• Display operating state of tape deck section alternately.
• If an error occurred, stop display.
14
2. Tape Deck Section
• The sequence during the aging mode is following as below.
• If an error occurred, stop display that step.
Aging mode sequence (Tape deck section) :
[ENTER/NEXT]
,
,
button to turn
?/1
Note: "TAPE
Rewind the tape A and B
"TAPE A AG-1"
Shut off
FWD play the tape A
"TAPE A AG-2"
2 minutes
Fast forward the tape A
"TAPE A AG-3"
Shut off or 20 seconds
REV play the tape A
"TAPE A AG-4"
2 minutes
Rewind the tape A
"TAPE A AG-5"
Shut off
FWD play the tape B
"TAPE B AG-2"
2 minutes
Fast forward the tape B
"TAPE B AG-3"
Shut off or 20 seconds
REV play the tape B
"TAPE B AG-4"
2 minutes
Rewind the tape B
"TAPE B AG-5"
Shut off
AG-
" is display of each step.
*
*
Advertisement
Table of Contents
