Ryobi RVC-1430PPT-G Owner's Operating Manual page 12

Removing And Cleaning Dry Filter (THIS FILTER IS
NOT WASHABLE)
1. Unlock and remove the fi lter retainer by turning
retainer handle anticlockwise.
2. Carefully hold and pull the dry fi lter up for removal.
(Fig. 24)
3. Clean the cartridge fi lter by gently tapping or
brushing dirt off. For optimal performance it is
recommended to regularly change this fi lter
depending on level of use (eg. 3-6 months).
4. Install cleaned or new fi lter into place as instructed
above.
INSTALLING AND CLEANING THE FOAM FILTER
Note: Unplug machine from the power outlet before
performing maintenance.
Installing Foam Filter
Follow instructions to remove dry dust fi lter fi rst before
changing to foam fi lter.
Carefully slide foam fi lter down over the fi lter cage
making sure the whole cage is covered. (Fig. 9 & 25)
Cleaning Foam Filter
Carefully remove foam fi lter. (Fig. 26)
Use a mild soap and water solution to wash foam fi lter
and rinse with clean water. (Fig. 27)
Allow fi lter to air dry before installing and using again.
FAQ'S
WARNING
To reduce the risk of personal injury, unplug the cleaner before performing maintenance/troubleshooting
checks.
Problem
The appliance doesn't work
Dust is escaping from the
motor cover
Low suction power and high
motor speed / vibrations
RVC-1430PPT-G - Version01.indd 12 RVC-1430PPT-G - Version01.indd 12
Cause
No power
Functional fault in the power cord, switch,
or motor
Tank is full of liquid
The dust bag is missing or damaged
Dust bag is full
Suction nozzle, hose, or tank inlet is
blocked.
12
SYMBOLS
CAUTION! WARNING! DANGER!
V
Volts
Hz
Hertz
Alternating Current
W
Watts
Please read the instructions carefully before
starting the machine.
Recycle
Do not dispose of electric tools together with
household waste material.
Electric tools and electronic equipment that
have reached the end of their life must be
collected separately and returned to an
environmentally compatible recycling facility.
Check with your local authority or retailer for
recycling advice and collection point.
European Conformity Mark
Solution
Check the power supply.
Have the damaged part checked by
qualifi ed personnel or replace it.
Empty the tank
Put in a dust bag or replace it.
Replace the dust bag
Check the suction nozzle, hose,
and tank inlet for obstructions.
26.05.2016 15:46:46 26.05.2016 15:46:46