Installing Optional Vga Module - Dell OptiPlex 7060 Tower Service Manual

Installing optional VGA module

1. To remove the metal bracket as shown below, insert a flathead screwdriver in the hole of the bracket [1], push the bracket
to release the bracket [2], and then lift the bracket out from the system.
2. Insert the VGA module into its slot from the inside of your computer [1] and connect the VGA cable to the connector on the
system board [2].
3. Replace the two (M3X3) screws to secure the optional VGA module to the system.
4. Install the system fan
5. Close the front panel
6. Install the:
58 Disassembly and reassembly
.
door.