Connect To Your Computer - Epson Stylus CX5400 Start Here Manual

7
Install Software and

Connect to Your Computer

The software works with Windows
OS 8.6 to 9.2.2 and 10.2.x. Follow the steps below (for Windows), or the steps
in the next column (for Macintosh).
Windows
1
Make sure the Stylus CX is not
connected to your computer,
then turn on your computer.
Note: If your Stylus CX is turned
on and connected to your computer,
you may see several New Hardware
Wizard screens. Click Cancel for
each of these screens and disconnect
your Stylus CX. You can't install
your software that way.
2
Insert your Stylus CX CD-ROM
in your CD-ROM or DVD drive.
3
When you see the message about
disabling your antivirus software,
click Continue.
4
Read the license agreement, then click Agree. The Software Installation
screen opens automatically.
5
Click Install.
Note: If the install screen
doesn't open automatically,
do the following:
For Windows XP: click Start >
My Computer. Then double-click
the EPSON CD-ROM icon.
For Windows 2000/Me/98:
double-click
Then double-click the EPSON CD-ROM icon.
6
When you see this screen, make sure
your Stylus CX is turned on, then remove
the sticker from the USB port.
7
Connect the
USB port on your computer.
8
Connect the
Stylus CX USB port.
After you connect your Stylus CX, Windows displays several messages
as it detects your device. If you don't see the messages, make sure
your Stylus CX is turned on.
® 98, Me, 2000, and XP, and Macintosh
My Computer.
flat end of the USB cable to any available
square end of the USB cable to your
®
continue