Table of Contents
Advertisement
To w ind tape at high speed
To fast w ind in
direction |
1
TUNING
÷ Press the STOP 7 key to stop fast w inding.
÷ The same operation is also available w ith the 4
and ¢ keys on the main unit.
Selection of TAPE equalizer (TAPE EQ.)
When playing a tape prerecorded w ith Noise Re-
duction system (such as the DOLBY NR) ON, be
sure to set the "TAPE EQ." ON for playback.
Lit w hen "TAPE EQ." is ON
TAPE EQ.
Each press sw itches the modes as follow s.
1 "TAPE EQ." ON
TAPE equalizer is used)
(
2 "TAPE EQ." OFF
TAPE equalizer is not used
(
÷ Select the " TAPE EQ. " ON mode according to the
recording condition of the tape.
To stop playback
STOP 7
To fast w ind in
direction \
1
)
AUTO/MONO
Selection of reverse mode
M ain unit only
1
Select "TAPE RVS".
\
\
2
Select.
1 " " : (ONE-WAY)
Only one side is played back (recorded), and
then the tape stops.
2 "
" : (REVERSE)
Both sides are played back (recorded), and
then the tape stops. When the tape transport
direction is " 2 ", the tape stops after one side
has been played (recorded).)
3 "
" : (ENDLESS)
Both sides are played back endlessly. (The
tape stops after recording onto both sides.
When the tape transport direction is " 2 ", the
tape stops after one side has been recorded.)
(The initial setting is "
3
Set it.
A tip for use of the tape counter
The tape counter is set to " 0000 " w hen a cassette
tape is loaded. By w riting dow n the counter read-
ing in case you w ant to interrupt recording (play-
back) in the middle of the tape, the memo w ill be
helpful as a reference for locating the same posi-
tion w hen continuing the recording (playback) the
next time. The tape counter figure decreases dur-
ing recording or playback of the back side (w hile
the 2 tape transport indicator is lit). To set the tape
counter to " 0000 ", open the cassette holder once.
Then the counter w ill be reset.
Playback of TAPE
\
\
"(REVERSE))
19
EN
Advertisement
Table of Contents
