Wireless Network Installation; Connect Wirelessly Using The Setup Wizard - Epson Artisan 710 Series Network Installation Manual

Wireless Network Installation

To connect to your printer wirelessly, you need to know the name (SSID) of your
wireless network. If it has security enabled, you also need to know the WEP key or
WPA passphrase. Write down your network and security information in the space
provided below:
■
Network name (SSID): _________________________________________
■
WEP key or WPA passphrase: ____________________________________
Note:
Your printer is compatible with 802.11b and 802.11g. If your router or access point
supports 802.11n (Wireless N), makes sure it is set to compatibility mode to allow
802.11b and 802.11g devices to connect to it.
Your printer supports the following wireless security modes: WEP , WPA, and WPA2.
If you don't know your wireless network name (SSID), WEP key, or WPA passphrase,
contact the person who set up your wireless network before you begin.
If your WPA passphrase contains upper- or lowercase letters, be sure to note it
correctly.

Connect Wirelessly Using the Setup Wizard

Follow the steps below to connect to your printer wirelessly.
1. Select
Setup
F
2. Press l or r to select
on the printer's control panel, then press
Network Settings
OK
, then press .
OK
Wireless Network Installation
.
5