Create An Ad-Hoc Wireless Connection - Epson Artisan 710 Series Network Installation Manual

4. Wait for the printer to connect to your wireless network (this can take up to
90 seconds).
Once it's connected, you see the
on the printer's control panel.
5. Continue with "Install Software" on page 24.
Note:
If the printer doesn't connect to your wireless network after 90 seconds, the SSID,
WEP key, or WPA passphrase may have been entered incorrectly. See "Connect
Wirelessly Using Advanced Setup" on page 9 to select your network settings again.
If the printer still doesn't connect to your wireless network, see "The printer cannot find
or connect to the wireless router or access point" on page 31.

Create an Ad-Hoc Wireless Connection

Use this setup method if you want to print wirelessly but do not have an access
point or router.
Important:
For Windows
cable, you need to disconnect it before installing software. When setup is complete,
reconnect your computer's Ethernet cable.
For Macintosh
cable or you use a modem for Internet access, you cannot set up your printer this way.
See "Connect Wirelessly Using the Setup Wizard" on page 5 or "Wired (Ethernet)
Installation" on page 23 to set up your printer.
1. Select
F
16
Wireless Network Installation
®
users: If your computer is connected to a network with an Ethernet
®
users: If your computer is connected to a network with an Ethernet
on the printer's control panel, then press
Setup
WiFi icon and a signal strength indicator
.
OK