AEG L7FBE941Q User Manual page 34

34 www.aeg.com
10.2 Loading the laundry
1. Open the appliance door.
2. Shake the items before you put them
in the appliance.
3. Put the laundry in the drum, one item
at a time.
Make sure not to put too much laundry
in the drum.
4. Close the door firmly.
CAUTION!
Make sure that no laundry
stays between the seal and
the door. There is a risk of
water leakage or damage to
the laundry.
10.3 Using detergent and
other treatments
If both AutoDose tanks are enabled in
the set programme, detergent and fabric
softener are automatically loaded.
If one of the AutoDose tank or both
are disabled (OFF) in the set
programme, proceed by manually filling
the product in the proper compartment.
10.4 Setting a programme
If you wish to change the
automatic detergent or
fabric softener dosage, enter
the AutoDose configuration
mode before proceeding
with any programme setting.
The configuration mode may
cancel temporary settings.
Please refer to "AutoDose
configuration mode"
paragraph in "The
AutoDose Technology
(Autodosing)" chapter.
1. Turn the programme dial to select
the desired washing programme. The
related programme indicator comes
on.
The indicator of the Inicio/Pausa button
flashes.
The display shows an indicative
programme duration, the maximum
declared load for the set programme
(only for a few seconds), the default
temperature, the default spin speed and
the washing phase indicators (when
available).
2. To change the temperature and/or
the spin speed, touch the related
buttons.
3. If desired, set one or more options
by touching the related buttons. The
related indicators come on in the
display and the given information
changes accordingly.
In case a selection is not
possible, no indicator comes
on and an acoustic signal
sounds.
10.5 Starting a programme
WARNING!
Make sure that the
detergent dispenser is firmly
closed, otherwise
programme won't start.
Touch the Inicio/Pausa button to start
the programme.
The related indicator stops flashing and
stays on.