Sharp UX-D50 Operation Manual page 12

Quick Reference Guide
Installation
1. Connect the handset and place it on the
handset rest.
2. Plug the power cord into a 220 - 230 V,
50 Hz, earthed (2-prong) AC outlet.
Caution: The power outlet must be
installed near the equipment and must
be easily accessible.
3. Connect the telephone line cord to the
TEL. LINE jack and a wall telephone
jack.
4. Attach the paper tray and paper tray
extension.
2
Loading the imaging film
1. Open the operation
panel (press ➊).
2. Remove the imaging
film from its
packaging. Cut the
band that holds the
rolls together.
3. Insert the green gears.
IMPORTANT: Do NOT discard the
green gears. They are not included with
replacement imaging film.
Make sure
the gears fit
into the slots
in the ends of
the rolls.
4. Insert the film into the print
compartment.
Thick roll
to rear
5. Rotate the front gear
Click!
as shown until the
film is taut.
2
1
1 slot
2 slots
Fit ends
of rolls
onto hubs