Table of Contents
Advertisement
8.
Power on the switch: Reconnect the previously removed power
sources to the switch. Check the Mgmt LED indicator on the switch's
front panel to be sure that the Management Module is operating
correctly. Refer to the table of LEDs in this guide for a description of
the LED indications.
Refer to the following manuals for the base unit for further details on using
this module:
VH-2402S/VH-2402S2 User Guide — connection options and network
applications.
VH-2402S/VH-2402S2 Management Guide — configuration options.
6 Installing the Module
- Connect one end of the interface cable directly to the
Management Module's console port and tighten the retaining
screws.
- Connect the other end of the interface cable to a terminal (in
some instances, an adapter may be required to make this
connection).
- From your terminal, start the terminal emulation program.
- Configure the terminal to the following communication
settings: VT100 emulation, 19200 baud, no parity, 8 data bits,
1 stop bit, no flow control, ASCII character set.
VH-SMGMT/VH-SMGMT2
Advertisement
Table of Contents
