Water Softener Filter (If Fitted); Installing The Filter - DeLonghi ECAM23270S Manual

7. Press the button to confirm. The descaling pro-
gramme starts and the descaler liquid comes out of the
cappuccino maker.
The descale programme automatically performs a series of
rinses and pauses to remove limescale deposits from inside
the machine.The descale programme starts and the des-
caler liquid comes out of the water spout.
After about 20 minutes, the
8. The machine is now ready for rinsing through with clean
water. Extract the water tank, empty, rinse under running
water, fill with clean water up to the MAX level, insert the
filter (if removed previously) and put the water tank back
in the machine. The
9. Empty the container used to collect the descaler solution
and replace it empty under the water spout.
10. Press the button to start the first rinsing. Hot water
flows out of the spout.
11. When the water tank is completely empty, the
and lights come on.
12. Extract the water tank, empty, rinse under running water,
fill with clean water up to the MAX level, and put the water
tank back in the machine. The
13. Press the button to start the second rinsing. Hot water
flows out of the spout and coffee outlet.
14. Press Ok and fill the water tank: the machine is ready for
use.
Please note!
If the descaling cycle is not completed correctly (e.g. lack of elec-
tricity) we recommend repeating the cycle.

WATER SOFTENER FILTER (IF FITTED)

Certain models are fitted with a water softener filter. If this is not
the case with your model, you are recommended to purchase
one from De'Longhi Customer Services.
To use the filter correctly, follow the instructions below.

Installing the filter

1. Remove the filter from the packaging.
2. Turn the date indicator disk (fig. 37) until the next two
months of use are displayed.
5. Press the button: the
lights shown in fig. 36
come on: and
flash.
6. Press the
to confirm. (If you want
to abort the operation,
press the
corresponding to
36
, and lights come on.
light comes on.
ight comes on.
button
button,
).
0,5 L
4. Extract the tank from the machine and fill with water.
,
5. Insert the filter in the water tank and immerse it com-
pletely for about ten minutes, sloping it to enable the air
bubbles to escape (fig. 39).
6. Insert the filter in the filter housing and press as far as it
will go (fig. 40A)
7. Close the tank with the lid, then put the tank back in the
machine (fig. 40B).
When you install the filter, it must be activated delivering hot
water until it flows regularly.
Important!
After two months (see date indicator) or when the machine has
not been used for 3 weeks, you should replace the filter with a
new one, repeating the procedure for the installation.
15
Please note
The filter lasts about two
months if the machine is used
normally. If the coffee machine
is left unused with the filter in-
stalled, it will last a maximum of
three weeks.
3. To activate the filter, run
tap water through the hole
37
in the filter as shown in the
figure until water comes
out of the openings at the
side for more than a min-
ute (fig. 38).
38
40A
39
40B