Pioneer AVIC-Z830DAB Operation Manual page 151

problem, contact your dealer or an
authorised Pioneer Station for
assistance.
Positioning is not possible due to
hardware error. Please consult your
dealer or local authorised service centre.
→ The location display is not possible due
to hardware failure.
– Contact your dealer or an authorised
Pioneer Station for assistance.
No GPS antenna. Check connection.
→ GPS reception is lost.
– Check the aerial connection. If the
message fails to disappear even after
the engine is switched off/on, contact
your dealer or an authorised Pioneer
Station for assistance.
GPS antenna problem detected. Contact
dealer or service center.
→ GPS aerial lead is short-circuited.
– Contact your dealer or an authorised
Pioneer Station for assistance.
Calibration will start, but may be
inaccurate without speed pulse.
→ The speed pulse sensor is not
connected correctly.
– Contact your dealer or an authorised
Pioneer Station for assistance.
Sensor error. Please contact your dealer
or Pioneer Service Center.
→ An error has occurred with the sensor.
– Contact your dealer or an authorised
Pioneer Station for assistance.
Detected unusual speed pulses.
→ The speed pulse cannot be detected
correctly.
– Contact your dealer or an authorised
Pioneer Station for assistance.
Detected changes in the installation
angle or position. The in-dash receiver is
updating the sensor learning data.
→ Changes in the installation angle or
position are detected.
– Wait until the sensor learning finishes.
Speed pulse wire is not connected. The
system will operate in simple hybrid
mode.
→ Speed pulse wire is not connected.
– The speed pulse cannot be detected if
the speed pulse wire is not connected
correctly.
DAB tuner
Z930DAB Z830DAB
Check Antenna
→ The aerial connection is incorrect or an
unusual voltage has been detected.
– Turn the ignition switch OFF and
connect the aerial correctly. After
connecting, turn back ON again.
Disc
Error-02-XX/FF-FF
→ The disc is dirty.
– Clean the disc.
→ The disc is scratched.
– Replace the disc.
→ The disc is loaded upside down.
– Check that the disc is loaded correctly.
→ There is an electrical or mechanical
error.
– Press the RESET button.
Different Region Disc
→ The disc does not have the same region
number as this product.
– Replace the DVD with one bearing the
correct region number.
- 151 -
Z730DAB Z7330DAB