Table of Contents
Advertisement
Section 4: Maintenance & Lubrication
Shear Bolt Protection
The driveline is equipped with a shear bolt to help protect
the machine from an overload such as product being fed
too fast, rotor knives jamming against a very hard object,
plugged rotor housing, and high speed start-ups.
Always determine the cause of the problem and fix it
before putting the chipper back into service. See your
Land Pride dealer when replacing shear bolts.
Shear bolt storage holes are located on frame rails on
either side. See Figure 1-6 on page 16.
Land Pride Shear Bolt Part No.
Part No.
Part Description
165.000.507 CO BOLT & NUT M10 x 60 CL.8.8
Long Term Storage
Clean, inspect, service, and make necessary repairs to
the implement when storing it for long periods and at the
end of the season. This will help ensure the unit is ready
for field use the next time you hook-up to it.
1.
Clean off any dirt and grease that may have
accumulated on the Wood Chipper and moving
parts.
2. Inspect all rotating components for entangled
material and remove.
3. Wash surfaces thoroughly with a garden hose or
power washer.
4. After washing unit, run machine for several minutes
to dry out the inside.
5. Check rotor knives for wear. Rotate rotor knives,
resharpen worn knives, or replace with new rotor
knives.
6. Check ledger knife. Rotate ledger knife or replace
ledger knife when required.
7.
Check twig breaker bar. Replace breaker bar if it is
bent, broken, worn thin, or has structural cracks.
32
WC1504 Wood Chipper 328-098M
Table of Contents
8. Inspect Wood Chipper for loose, damaged, or worn
parts. Adjust and tighten loose parts and replace as
needed.
9. Repaint parts where paint is worn or scratched to
prevent rust. Ask your Land Pride dealer for aerosol
touch-up paint. They are also available in touch-up
bottles with brush, quarts, and gallon sizes by adding
TU, QT, or GL to the end of the aerosol part number.
Land Pride Aerosol Touch-up Paint
Part No.
821-011C
821-058C
821-066C
821-070C
10. Replace all damaged or missing guards and decals.
11. Lubricate as noted in "Lubrication Points" on
page 33.
12. A light coat of oil or grease may be applied to the
rotor knives, ledger knives, and to any exposed
unpainted parts to minimize oxidation.
13. Store Wood Chipper on a level surface in a clean, dry
place. Inside storage will reduce maintenance and
make for a longer Wood Chipper life. Tarp Wood
Chipper if stored outside.
14. Unhook Wood Chipper from the tractor. See
"Unhook Wood Chipper" on page 23.
Part Description
PAINT LP BEIGE SPRAY CAN
PAINT GREEN SPRAY CAN
PAINT ORANGE SPRAY CAN
PAINT GP GLOSS BLACK SPRAY CAN
2/10/21
Advertisement
Table of Contents
